I have a 1750 with a WIC-1ADSL and WIC-2FXO, configured as a H.323 gateway in CCM 4.1(3). The latest IOS that supports this config is c1700-k9o3sv3y7-mz.122-8.TPC10a, which I am running. The router is locking up and crashing with a SIGTRAP exception shortly after answering / making calls through the FXO ports. I've attached the config / show ver / show diag. Can anybody suggest where I am going wrong or is it simply a case that I am not going to be able to run this hardware config with this IOS?
Signal Track exception is classfied under possible software realted problem which i feel can be resolved by an upgradtion to a GD or stable IOS code with same feature set and may be in the same version or in higher version.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...