Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2 Dial-peer, same extension

Hi,

How can I configure 2 dial-peers with the same extension number, all calls will go to the first phone, and the call will only go to the second phone when the first phone is busy.

Thank you in advance.

  • Other Collaboration Voice and Video Subjects
3 REPLIES
Cisco Employee

Re: 2 Dial-peer, same extension

You didn't specify pots or voip so I will assume voip

dial-peer voice 1 voip

 destination-pattern 1234

 preference 2

 session target ipv4:10.1.1.3

!

dial-peer voice 2 voip

 destination-pattern 1234

 preference 4

 session target ipv4:10.1.1.3

New Member

Re: 2 Dial-peer, same extension

You may wish to investigate the dial-peer hunt global configuration command which alters the way IOS searches dial-peers for matches.

New Member

Re: 2 Dial-peer, same extension

Use the preference command. 0 is the highest (default). Here's an example:

dial-peer voice 1 pots

destination pattern 123

port 1/0/0

!

preference 0

dial-peer voice 2 pots

destination pattern 123

port 1/0/0

preference 1

99
Views
0
Helpful
3
Replies
This widget could not be displayed.