11-10-2005 09:39 AM - edited 03-13-2019 11:11 AM
Right now we have two PRI's from the Telco with separate D-channels put into a group.
They are able to group the two and give me one D-channel on their side, but how do I set it up on my side?
Dave
11-10-2005 10:00 AM
This configuration is called Non-Facility Associated Signaling (NFAS) and is not supported on CallManager MGCP. You need to use H.323
Reference the following document for H.323 NFAS configuration:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5012/prod_release_note09186a00801066bf.html#281315
Chris
11-13-2005 08:12 PM
Hi Dave,
What do you want to gain with this setup?
If your primary goes down, you loose the lot :-(
You better have 2 seperate PRI's and have them grouped incoming and outgoing.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: