Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2 pstn specific outbound calls

hi,

i have one gateway router 2621 for ccm outbound calls, i need configure specific outbound calls for E1 because in one E1 only have 100 calls to long distance and other E1 200 calls.

router gateway with two e1 with 20 channels to pstn with diferent carrier.

i have only this configuration in the router:

sccp local FastEthernet0/0.10

sccp

sccp ccm 192.168.10.5 priority 1

sccp ip precedence 3

5 REPLIES

Re: 2 pstn specific outbound calls

I'm not sure of your exact question, but here are a couple of links regarding setting up MGCP/H.323 gateways with Callmanager.

How to Configure MGCP with Digital PRI and Cisco CallManager

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

Cisco IOS H.323 Gateway Configuration for Use with Cisco CallManager

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094636.shtml

Hope this helps. If so, please rate the post.

Brandon

Green

Re: 2 pstn specific outbound calls

Mmm, This is not possible in CCM, you may check that will your Telco so they restrict that.

Normally you restrict either call duration or Long Distance access. Telco should be able to do this.

New Member

Re: 2 pstn specific outbound calls

then, i can only balancing outbound calls with preference in dial-peer...?

New Member

Re: 2 pstn specific outbound calls

Hi,

Even i m not clear abt ur question but i think you need to read some stuff about MGCP configuration, Route pattern, route list , route group...that should help you.

New Member

Re: 2 pstn specific outbound calls

the router not support mgcp becauso is E1 to pst configured in R2 not isdn or ss7.

143
Views
0
Helpful
5
Replies
CreatePlease login to create content