I looking at a 2600XM with CCME 3.1 and AIM-CUE and using either the NM-HD-2V or 2VE module with VIC-4FXS/DID and was wondering if the FXS ports have to have PVDM like a AIM-VOICE-30 card so that the FXS cards terminate to?
I do not believe that you need it, but I want to make sure.
Re: 2600XM - NM-HD-2V or 2VE with CCME and AIM-CUE?
The NM will have the DSP resources for the VICs, so you won't need an AIM card... Depending on the codec you use, you might be able to support only 6 simultaneous calls with the HD-2V card, so that might be something to think about if you're trying to put 2 of the 4FXS vics in that NM...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...