Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2651XM AIM-voice30 and MN-1V compatibilities

hi all

i've got a 2651XM bundle (with AIM-voice30),i need to install a vic-2BRI.

Do i need a nm-1V or can i install it on wic location?

can i install a vic-fxs and a vic-2bri without nm-2V in wic location?

in other words do i need nm (hdv,1or2v) if an aim voice is in my 2651?

if i have a wic-bri ,a wic-1T in my 2651XM can i install vic-2bri in a NM-1V and use 4 voice channels (2 with nm,2 with AIM)(nm1V support only 2 channels)

thanks in advance

3 REPLIES
New Member

Re: 2651XM AIM-voice30 and MN-1V compatibilities

Alain

You can not install the VIC2BRI into a wic slot, the reason is that there is no DSP's on the main router board.

The VIC2BRI needs to be installed into the NM-2V which has four DSP. Remember that each BRI supports 2 64Kb channels therefore you will need four DSP's.

So an NM-2V can support one VIC2BRI, four FXS or Four FXO

An NM-1V will only have 2 DSP's and will only support two FXS or two FXO

I think there is an NM-2VE which has six DSP's, I will have to see if this product exist's.

Regards

Bill Hempstead

Senior Network Engineer

Defence Housing Australia

New Member

Re: 2651XM AIM-voice30 and MN-1V compatibilities

Bill,thanks for your answer,

As i said i've got a aim voice 30 dsp in my 2651

so my questions are still valid

in fact i have not yet this 2651 but i plane to buy it so i can't test the config.

Regards

Alain

New Member

Re: 2651XM AIM-voice30 and MN-1V compatibilities

The AIM-VOICE-30 only supports the VWIC cards such as the VWIC-1MFT-E1.

To use any of the VIC-2BRI cards you'll need an NM-1V or NM-2V. Note that the NM-1V will only allow you to use a single BRI port on the VIC-2BRI as it only has enough DSPs for two calls.

The new VIC2-2BRI cards need the NM-HD cards like the NM-HD-2V.

Regards,

Justin

134
Views
0
Helpful
3
Replies