A client has two Organisations within a single site and wants to use CME on a 2800 ISR router. Can the two PSTN connections be connected to the single 2800 ISR and more importantly can outgoing call costs be identified for both companies using a single router.
I think this is possible. You can use COR and allow phones from company 1 to use PRI 1 and block company 2. And allow company 2 and block 1 for PRI 2. If the phone company provides separate billing for each PRI than you should be done. If not, you would need to collect call data and then analyze it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...