I have 2 2811 routers, I used to have console access to the routers up until I issued a write erase command (to clear the existing config) and reloaded. Cisco SDM was installed I am not sure if that is part of the problem. I checked the console cable and it is fine. This happend on both routers, there is no output when a console window is open. I have checked over and over to confirm the settings for the console baud etc. and they have all been correct (I used hyper terminal and putty and I connected to other devices without issue). Any ideas what has happend? On one of the routers I formated the flash and installed a new IOS. This is something I have done many times over and this is the first time I have encountered this problem.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...