I am trying to verify a code that will recognize a WIC-1ADSL card in a 2821. The Cisco Software tool page shows that 12.4.10 IPVOICE code has support for this but the card is not seen on the router. When I try the enterprise version 12.4.9(T1) It does't see that card either but shows a VPN module??
Does anyone know what release will work? I am replacing 2620 routers (12.3.19) that have these cards in them for Disaster Recovery. I need support for ADSL- Asymetric Digital Subscriber Line support.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.