11-02-2006 01:35 PM - edited 03-13-2019 03:39 PM
Guys,
I am doing the T1 PRI connection from Option 11 to cisco 2851.
I have configured the 11C as user side / dms100 and cisco router as network side / dms100.
I have configured the router but when I give the command " sh isdn status" then it shows the L1 as deactivated !!
Any thought..
11-02-2006 02:01 PM
What does a show controller t1 X/X/X indicate?
How about a show int SX/X/X:23
Is this using Call Manager or just VOIP?
Can you post your config?
11-03-2006 07:25 AM
it's showing down , down..
It's just VoIP..
11-02-2006 02:29 PM
Are you using a T1 crossover cable between the two systems?
11-03-2006 07:26 AM
yeah , i am using crossover cable..
If we do the loopback then it is going up /down..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide