Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3 channel groups on a MFT module?

I have a customer who wants to bring in 2 channel groups of PPP plus one group of Voice on a single T1

1-12 PPP to another office

13-18 PPP to Internet (will be running FW feature set)

19-24 x-connected to second MFT port via connect command (for PRI to PBX)

My question is can this be done with the VWIC-2MFT-T1-DI and do we require the T train of IOS to pass the channels of voice?

We are only passing them not processing them so shouldn't this be dealt with at layer one by the card?

Thx

Brian

1 REPLY
New Member

Re: 3 channel groups on a MFT module?

the last time i tried to create (2) channel-groups for data on mft, it was not supported, but that was some time ago.

88
Views
0
Helpful
1
Replies
CreatePlease to create content