04-01-2002 11:09 PM - edited 03-12-2019 06:32 PM
Does anybody know when the 3640 E1 can be controlled by the callmanager with MGCP?
I am using IOS 12.2(8)T at the moment.
Regards,
Sascha
04-02-2002 05:42 AM
The only software that can do this at the time is 12.2(2)xn. Here are some config information for you.
Thank you,
-Mckee
04-02-2002 09:18 AM
Here is a brief description of supported voice and non-supported connection types with 12.2(2)XN taken from the Release Notes - Hope this helps:
Supported Voice Connection Types
For Cisco IOS Release 12.2(2)XN, the software and hardware have been tested for MGCP support for the following voice connection types:
User and Network side ISDN (PRI T1/E1)
T1 CAS
E&M
Caller ID for FXS
The following summarizes the T1-CAS signaling types that are supported in this release:
E&M Delay Dial
E&M Wink Start
MF and DTMF Signaling
The following T1-CAS signaling types are NOT supported with MGCP mode in this release:
E&M FGD
FXO-melcas
FXO-melcas
R2-analog r2-compelled, non-compelled, semi-compelled
R2-digital r2-compelled, non-compelled, semi-compelled
R2-pulse r2-compelled, non-compelled, semi-compelled
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide