Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.

3640 E1 IOS with MGCP

Does anybody know when the 3640 E1 can be controlled by the callmanager with MGCP?

I am using IOS 12.2(8)T at the moment.

Regards,

Sascha

2 REPLIES
Cisco Employee

Re: 3640 E1 IOS with MGCP

The only software that can do this at the time is 12.2(2)xn. Here are some config information for you.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122limit/122x/122xn/122xn2/ft_ccm.htm

Thank you,

-Mckee

New Member

Re: 3640 E1 IOS with MGCP

Here is a brief description of supported voice and non-supported connection types with 12.2(2)XN taken from the Release Notes - Hope this helps:

Supported Voice Connection Types

For Cisco IOS Release 12.2(2)XN, the software and hardware have been tested for MGCP support for the following voice connection types:

User and Network side ISDN (PRI T1/E1)

T1 CAS

E&M

Caller ID for FXS

The following summarizes the T1-CAS signaling types that are supported in this release:

E&M Delay Dial

E&M Wink Start

MF and DTMF Signaling

The following T1-CAS signaling types are NOT supported with MGCP mode in this release:

E&M FGD

FXO-melcas

FXO-melcas

R2-analog r2-compelled, non-compelled, semi-compelled

R2-digital r2-compelled, non-compelled, semi-compelled

R2-pulse r2-compelled, non-compelled, semi-compelled

126
Views
0
Helpful
2
Replies
CreatePlease to create content