We are trying to run Voice betwen 3640 [E&M, 12.0(4)T] and 1750-2v[E&M, 12.0(5)XQ1] but it seems call goes till each router but no end to end connectivity happens. I tested with SHOW CALL ACTIVE VOICE BRIEF output , it gives calls being generated at each ends(routers). Can someone help me about what must be the cause? & useful links/resources to overcome it.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...