I want to set up a voice trunk between two offices in order to eliminate the cost of toll calls. Will I be using a Cisco proprietary PBX that connects to the existing phone systme and provides fail-over to the PSTN network? The last time I checked, there was a software package that ran on an NT 4.0 server and provided that capability.
The routers will also be the edge router to the ISP, and I want to have multi-homed BGP capability and Firewall capability. Is this possible?
Check out the Cisco Call Manager in which you can effectively use the leased line for voice which will be carried as data packets and can be used for data and voice. And it will work out cheap for Toll calls.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...