I need to connect a 3745 PRI gateway to a pair of 4507R Core switches. The 3745 has two Fastethernet interfaces. Can I connect one to each core switch for fault tolerance but use a single IP address for the router? Bridging/loopback/????
What protocol or configuration command are you thinking of when you say one of the fastethernet interfaces can be in a standby mode for the other. I am assuming it is not HSRP since both of these interfaces are physically on the same router.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.