Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3745 MGCP Cannot call out HELP!

Hello,

I have a 3745 with IOS 12.3(6) running IP PLUS. I have 2 - NM-HDV with 2 2MFT-T1 cards in each. I only have controller T1 1/0 operational at this time.

Therefore I have interface Serial 1/0:23 and Voice-Port 1/0:23

I have the dial-peer 10 voice pots

incoming called number.

destinationa pattern 9T

application mgcpapp

direct-inward-dial

port 1/0:23

The L2 of the PRI is up Mutliple Frames Established.

I have all my Route Patterns tied to Route Filters.

9.@ LongDistancePT LongdistanceRF PreDot

I try to make a call to the PSTN and it drops the call immediately.

I looked at the debug ISDN q931 and saw that I was sending out the appropriate numbers and it was not sending the nine.

It was working for a short while, I tried to make some changes because when trying to see if SRST was working there was NO dial-tone. After making minor changes, it stopped working again even with CCM up.

I TFTP the working config back and still it disconnects the call immedaitely.

Should I use 12.3(7)T IP VOICE instead of the IP PLUS?

  • Other Collaboration Voice and Video Subjects
2 REPLIES
Cisco Employee

Re: 3745 MGCP Cannot call out HELP!

Could you post the whole config. I have worked with a 3745 and currently 3725 and can make calls out without any problems. So it may be a simple configuration thing.

New Member

Re: 3745 MGCP Cannot call out HELP!

As soon as I get the configs I will send them to you just send send me your e-mail address to bhenry33@adelphia.net

Thanks!

93
Views
0
Helpful
2
Replies