Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3825--NM-2CE1T1-PRI

This (2) Port NM should allow to be configured for either Data T1 or Voice T1 or just the Data Only.

Please Clarify

1 REPLY
Hall of Fame Super Red

Re: 3825--NM-2CE1T1-PRI

Hi Ali,

This module is "Data Only". Have a look at the description for the NM-1CE1T1-PRI;

Module as "Data Only",

The versatility of Cisco 2610-51XM, 2800, 2691, 3660, 3700 and 3800 series routers is demonstrated by their broad support of E1/T1 connectivity and Integrated Services Digital Network Primary Rate Interfaces (ISDN PRI). Customers continue to deploy E1 and T1 circuits for Wide Area Network (WAN) connectivity, ISDN dial-backup, and digital modem termination in the Power Branch Office Environment. Cisco now makes it possible to terminate T1 and E1 PRI connections in a single network module. Available in single and dual port models, the NM-1CE1T1-PRI and NM-2CE1T1-PRI cards coupled with Cisco 2610-51XM, 2800, 2691, 3660, 3700 and 3800 Series routers, enhance and simplify customers' WAN connectivity options

The Cisco E1/T1 ISDN PRI Network Module's integrated channel service unit (CSU) provides direct connection to the Telecommunications network, thus allowing customers to consolidate customer premises equipment (CPE). This provides multifunction dial access aggregation, routing functionality, VPN and firewall security, and other capabilities right inside the Cisco router in power branch office environments. Both the 1-port and 2-port versions offer support for balanced and unbalanced E1 connectivity and conform easily to customers' specific applications.

The Cisco E1/T1 ISDN PRI network modules also supply connectivity for internal digital modems in the Cisco 3660, 3700 and 3800 series routers, with connectivity options for PRI, T1 channel associated signaling (T1-CAS), and E1-CAS R2 signaling. This provides for a high concentration of V.92-compatible modems, while still allowing expandability for other critical services.

FEATURES AT-A-GLANCE

Cisco IOS Software configurable for T1 or E1 operation

Balanced or unbalanced E1 termination in the same module

Integrated CSU/DSU (channel service unit/data service unit) per port

Full or fractional E1/T1-can be fully channelized

***Supports PRI for data, T1-CAS, and E1-CAS R2 signaling

E1 unframed and framed modes (G.703/G.704) available

Interoperates with NM-xDM digital modem network modules

Bantam (tty) jacks for easy network monitoring

V.54 loopback compatible

Supported on Cisco 2610-51XM, 2800, 2691, 3660, 3700 and 3800 Series routers

Online insertion and removal (OIR) supported on Cisco 3660 3745 and 3845 routers

On-board expansion slot for future technologies

From this doc;

http://www.cisco.com/en/US/products/hw/modules/ps2797/products_data_sheet09186a0080189f95.html

See also, this good doc;

Relevant Interfaces and Modules

http://www.cisco.com/en/US/products/ps5854/products_relevant_interfaces_and_modules.html

Hope this helps!

Rob

347
Views
0
Helpful
1
Replies