Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 
Community Member

3825 + syslog data

Hi, we've had a need to monitor all incoming calls so that we can go back and see caller number and called number in case of an outage so that missed faxes can be tracked back.

Using the syslog feature, I've been able to log these calls in the following format...

date time Local7.Info x.x.x.x 355864: *May 31 14:53:10: %ISDN-6-DISCONNECT: Interface Serial0/0/0:2 disconnected from xxxxxxxxxx , call lasted 395 seconds

In all cases, this is only showing the phone number of the external caller, regardless of whether we called them or they called us.

Since we need to know who they were trying to reach, we need the internal user to show in this information too, which I can see using a debug isdn q931 command on the gateway itself.

Any ideas? Is there a way to extend the data that is provided by syslog or do I need to go a different route?

Using a 3825 gateway. thanks.

CreatePlease to create content