Re: 3825 would not recognize a 2MFT1 controller card
The card says it is vwic2-2mft-t1/e1. The command that you mentioned is it a hidden command? i tried using the command in global config mode and i do not see any options, it does not even like the work "card".
I have not installed PVDM's yet in the router, not sue if that would impact anything.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.