Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3Com NBX 100 to ATA

Hi, I have a 3Com NBX PBX and i have to connect this to Cisco ATA 186/188

Can i do this?

Wath i need for this?

Regards.

  • Other Collaboration Voice and Video Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 3Com NBX 100 to ATA

You need to connect fxo to fxs. So using a trunk port on the NBX to connect to a vic-2fxs should work.

Vance

4 REPLIES
New Member

Re: 3Com NBX 100 to ATA

Hello,

I've never worked with an ATA186 yet, but I understand it supports h.323. If you buy the NBX h.323 module and load it on a server, you should be able to pull this off. However, it would probably just be cheaper/easier/better to just implement one of 3Com's little ATAs...

Why this specific configuration?

Good luck,

Vance

New Member

Re: 3Com NBX 100 to ATA

The scenario can change.

NBX -- FXO -- 1751 --- WAN

but i looking for all solution posible-

Can i connect NBX-FXO cards to VIC-2FXO on 1751 Router?

New Member

Re: 3Com NBX 100 to ATA

You need to connect fxo to fxs. So using a trunk port on the NBX to connect to a vic-2fxs should work.

Vance

New Member

Re: 3Com NBX 100 to ATA

but i can make call in both way?

I hear that ATA connected to PBX only receive calls.

320
Views
0
Helpful
4
Replies