Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

4 port Ethernet Switch WIC for 1760

Has anyone used the 4port Ethernet Switch WIC module for the 1760 in an IP Tel environment?

Looking at the specs, no inline power but it should support multiple 802.1q vlans per port which would let me plug in a phone in w/ PC plugged into phone. I would need to use power bricks for the phones, but that's ok...

Since I don't have my hands on one of these modules to test with, can anyone share their experiences with this module?

Thanks!

John

1 REPLY
New Member

Re: 4 port Ethernet Switch WIC for 1760

Unfortunately this WIC has quite a few limitations including no support for dynamic or voice vlans. So my point is the pc would have to be plugged into one port configured for a data vlan and any phones would have to be plugged into another port that's statically set to a "voice" vlan.

Please refer to the following link for the lengthy list of its limitations.

http://www.cisco.com/en/US/products/hw/modules/ps2641/products_installation_guide_chapter09186a008007cb78.html

88
Views
0
Helpful
1
Replies