Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

4000 QoS

Dave,

I have read the 4000 QoS documents many times, but still can't quite work out the details of the command "set qos map 2q1t 2 1 cos 4-7".

It doesn't state anywhere that the 2nd queue is a priority queue. is that the case?

Also could you explain the drop threshold part, as thats not too clear either.

Many thanks

Mark.

1 REPLY

Re: 4000 QoS

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

114
Views
0
Helpful
1
Replies
CreatePlease to create content