4FXO ports are used as backup for T1/PRI during SRST, in which there are a few different pots dial-peers to T1/PRI. My question is if there is some easy way to configure the pots dial-peer for 4 FXO as lower preference than PRI. Otherwise, I have to write many same dial-peers with different FXO ports.
Can I configure the 4FXO as a trunk,and create one pots dial-peer for each destination-pattern to the 4FXO ports as backup? Is there any example?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...