Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Silver

6608 blade..

Hi,

Customer has a 6608 blade and requested to configure the first E1 channel for tests with a separate access number. Is that possible?

Thanks in advance..

Marina

  • Other Collaboration Voice and Video Subjects
4 REPLIES
Cisco Employee

Re: 6608 blade..

If you mean just a single B channel on an E1, then no we do not have a way to do that. But if you are referring to an entire E1 for testing with a separate access number, yes that is possible.

Silver

Re: 6608 blade..

Yes, I meant a separate B channel...Thats what i told to the customer but they dont believe thats impossible :)

Thanks

Re: 6608 blade..

Marina,

If they have a lot of money they could request a circuit from a carrier with only 1 channel active. Chances are they'll be told where to go, and they will not like the answer.

You can of course connect an E1 to a sub configured (less than 30 channels) circuit and any request for an unconfigured channel will be rejected by the carrier and back to the phone via CM.

If the customer doesn't believe you tell him to order the circuit himself and aggree to connect to it when it turns up, after 15 minutes he'll be back on the phone apologising.

Paul

Silver

Re: 6608 blade..

Hi Paul,

Thanks ..that was a good one!!will give it a try next week :)

Marina

269
Views
0
Helpful
4
Replies