All of sudden , 6608 transcoder only can accept one unity access, Phone shows connected but hear nothing from unity if second phone press message button to access unity. I can see 6608 used 2 dsp resource 9/6 transcoding 2 33554552 33562657 10.197.4.49
33554555 33562801 10.201.4.4
After i reset the 6608 module, it works again. Has anybody have this issue before. I am just worrying about the performance of the 6608 because as soon as this going to production, there will be more people access unity simutanously through the transcoder.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.