Are their any special PRI gateway configs that need to be done to get 711 dialing to work correctly. The called number is being sent to the carrier correctly which then initiates the 1-800 number to the 711 service center, but once it reaches that point it comes up undefined. So, the 711 service center rejects the call. The carrier did recognize a parameter coming across in the dial trace, "originating number path screening." Neither one of use knew what that was, but was originating from the CCM system. Thanks.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...