I recently built an ICS7750 running CCM 3.3(3) and ICS 2.6(2). Everything is working fine (phones register etc. etc.) but when I plug in a 7902 I have, it, unlike the 7940's and 7960's I have, fails to register with CCM. It seems that the 7902 is failing to obtain the TFTP address through DHCP.
I know that ICS uses CNR for DHCP services. Is CNR not setting option 150 in the scope (i.e. is it using some other method to communicate the TFTP address to the phones). Since the 7902 is ATA based is it possible that it looks for the TFTP address in a different way than the 7940/60's. When we plugged the 7902 into our corporate network with server based CallManagers, it worked fine. Also, when we hard code a TFTP address in the 7902, it successfully registers with the ICS.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...