I have a 7905 IP phone. I have set up several speed dials via the web interface, and would appreciate some help on two issues:
1. Why is there only the first 4 locations available directly (ie. by browsing from the phone). All the rest 95 are only available by entering their exact number.
2, Why the name of the speed dial is not shown after the number is dialed? This is not trivial for the first 4, but as you can realize it can be a problem with the rest, since you must always be sure that you have made no mistake in the memory number.
A user can configure up to 99 speed-dial entries on a phone. Speed-dial entries that are not assigned to the speed-dial buttons on the phone are used for abbreviated dialing. When a user starts dialing digits, the AbbrDial softkey appears, and the user can access any speed-dial entry by entering the appropriate index.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...