Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

7910 power inline??

Hi, i want to know if i can power in a 7910 ip phone by the ethernet port. i've read that it's posible by cdp, but i haven?t found more information.

1 REPLY
Hall of Fame Super Red

Re: 7910 power inline??

Hi Luis,

This is very possible,we use some 7910's that are all using PoE. Have a look;

48 VDC required; can be provided down the LAN using Cisco Discovery Protocol (CDP), or can be supplied locally at the desktop using an optional AC to DC power supply, CP-PWR-CUBE-3=. This power cube also requires ordering one of the AC country cords.

From this good doc;

Cisco Unified IP Phone 7910G

http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet09186a0080091983.html

Hope this helps!

Rob

Please remember to rate helpful posts.....

175
Views
3
Helpful
1
Replies
CreatePlease to create content