12-29-2005 08:44 AM - edited 03-13-2019 11:42 AM
I have 2 7912s with the red and green LEDs stuck on at power up, no display. I can't enter any reset commands. Has anyone seen this before? These were spares that had never been powered up til now.
Thanks for any suggestions!
12-29-2005 10:18 AM
Are you sure they are set-up in call manager? They may not be registering. Check the following website for detailed troubleshooting and repair advice.
Hope this helps.
Steve
12-29-2005 01:33 PM
Yes, they are there. The phones go straight into this immediately at power-up, which is not the behavior of undefined ip phones anyway.
Thanks!
12-30-2005 02:35 PM
Hi,
I've had a phone doing exactly this. I send it back to Cisco. Dead on arrival.
This is not a misconfiguration issue. Phone doesn't do or start doing anything and cannot be interacted with.
Erik
12-30-2005 10:07 PM
That's what TAC said, RMA'd the phones today, thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide