Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7914 Expansion Module

Hello, I installed an expansion module on a 7971 desk phone but all the lights are a steady amber. I have configured 22 of these thus far with no issues. The 7914 works on other phones. I have replaced the phone and the connecting cables but have the same result. The issue must be in the configuration but i have checked it several times. The phone is configured to allow the module on the system and the config also shows the button assignment. The phone system has also been rebooted. Any ideas?

2 REPLIES
New Member

Re: 7914 Expansion Module

I am having the same issue as you but with a 7962 phone and 7915 add on, all the lights on the add on are amber. Did you get yours resolved?

New Member

Re: 7914 Expansion Module

It turns out that my issue was being caused by a faulty switch port. Once I connected to a known good port, everything was fine. Have you tried a factory reset on the phone?

218
Views
0
Helpful
2
Replies