The Default Administrator password for our 7935 was inadvertantly reset and is no longer **#. To complicate matters, it is no longer registered with CCM. I would like to put the default factory settings on it again but I cannot initiate anything. Is there a key sequence I can push to do this? or something else I could try?
I would assume that you need to be logged in as the admin to reset the password so might not be of much help in this instance.
However this might help:
When the Cisco CallManager release is changed, and the IP Conference Station is downgraded from the P00503010400 release to the P00503010300, P00503010200, or P00503010100 release, the administrator password is lost.
Workaround: On the IP Conference Station, press **1 to restore the factory default settings.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.