I need to configure tens of phones with *static* network settings. Besides scrolling menus, and typing in IP addresses and stuff, can anybody propose a more intelligent way of doing it - connecting a cosole to the phone, telneting into the phone (I don't know whether those are possible options), etc?
I am not sure if you are looking for solution that is addressed by the BAT (Bulk administration tool). Here you can add as many phones you want to the CM cluster by just gathering the MAC address available on the phone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.