Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

7941 problems with bulk-speed-dial

We just upgrade de 7941 firmware from SCCP41.8-2-2SR1S to SCCP41.8-4-1SR1S.

Now we have a problem. From those phones, they can not use de bulk-speed-dial. These only happens since the firmware upgrade.

The CCME version is 4.1(0).

I have the bulk-speed-dial in telephony service. All the other phones can use the bulk speed dial. With the earlier firmware version, 7941 phones work just fine.

Any ideas ??

  • Other Collaboration Voice and Video Subjects

Re: 7941 problems with bulk-speed-dial

1. Can you verify or if not do the following

- no create cnf / create cnf under telephony-service and reloaded the phones

2. You have the correct format for your bulk speed dial list.

You have these fields: prefix to dial; actual number wanting to dial; description; and then these two last fields are optional append and hide. Verify your configuration Use this command

show telephony-service bulk-speed-dial

New Member

Re: 7941 problems with bulk-speed-dial


I already solve the problem with another firmware to 7941 phone (8-3-4SR1S).

Best regards,

Nelson Mendes

This widget could not be displayed.