If I take a 7960 and put it outside of a PIX and modify the cnf.xml file to point to the NAT'd IP of CM and open port 2000, should I be able to pass calls through the PIX? I can get it to register with the CM, but when I make calls, there is no voice. I have fixup for sccp and h323 turned on. ANy ideas? FYI, when I do a "show skinny" on the PIX, it shows the internal IP of the device I am calling.
I don't know if this helps, but we had to do "no fixup protocol skinny 2000" on our PIX.
We run LAN-to-LAN VPNs between PIX's. We placed a 7940 at a remote site. The phone would register will CCM at our Data Center, the calls would ring, but once you picked up the handset the call failed (no voice).
I spent an hour on the phone with TAC who found that the "fixup skinny" was causing the problem. I don't remember exactly but something with ports not matching up on both sides once the two phones tried to pass packets over the WAN. Issued the "no fixup" command above and everything worked just fine.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4