Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7961 Local Directory and Time

Hi,

We have the following CME system:

Cisco 2851, 12.4(4) XC4 IOS, CME 4.0(3)

The 7941's are all ok however the 7961's are not displaying the local directory and the time is also out by 4 hours.

Has anyone come across this please?

3 REPLIES
Hall of Fame Super Gold

Re: 7961 Local Directory and Time

Please upgrade IOS (XC6 if you want CME 4.0, XJ4 if you want CME 4.1) and phone firmware, for example SCCP41.8-0-4SR3AS.

Hope this helps, please rate post if it does!

New Member

Re: 7961 Local Directory and Time

Thanks, I have rated the post as 5. I will try the upgrade though will need to free up some flash memory for the new ios. As we have 4.0 I will go for XC6. Is this a known issue by the way?

I also found out that the 7961 do not show the new firmware after an upgrade and a reset. It still shows as TERM61.DEFAULT. Cannot figure out why.

Furthermore the known bugs generally offset the time by an hour (DST). Four hours in our case is a bit strange. Maybe the current 7961 load is not reading the timezone config correctly.

Hall of Fame Super Gold

Re: 7961 Local Directory and Time

Thank you for the nice rating. Now for your concerns:

- I see that XJ fits where XC does in terms of flash.

- configure load with the SCCP.... filename. term61.default is only used for factory reset recovery.

And I don't know the reason but I think you will be Ok with new software and firmware.

141
Views
5
Helpful
3
Replies
CreatePlease to create content