Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

7961 phone enters digits while on conf call, says invalid

When a user calls into a conf bridge and it asks for passcode, user enters number and conf service says number invalid. I know the passcode IS valid. Does not happen on all phones, which normally would lead you to "phone dial pad is bad" resolution, but it happens on a lot of brand new phones. IS there some setting in parameters that would effect the dtmf signalling after connnected, is there a known bug with certain phone loads, etc ?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 7961 phone enters digits while on conf call, says invalid

This is a bug I filed on the phone loads for 8.4.1 and 8.4.1 SR 1.

Upgrade to 8.4.2 or later and you'll be fine.

-nick

2 REPLIES

Re: 7961 phone enters digits while on conf call, says invalid

This is a bug I filed on the phone loads for 8.4.1 and 8.4.1 SR 1.

Upgrade to 8.4.2 or later and you'll be fine.

-nick

New Member

Re: 7961 phone enters digits while on conf call, says invalid

Thanks a bunch ! I was really hoping that was all it was. I appreciate your time in answering so quickly.

132
Views
0
Helpful
2
Replies