I have an IP Phone 7970, connected onto a non-Cisco LAN Switch. After using for a very short period of time, the switch port disable itself. Even I disconnect the IP Phone and plug a normal PC onto that LAN port, it can't be workable again. I've tried on two Switches and get the similar symptom. (The 7970 is powered by Power Adaptor.)
Has anyone got similar symptom in the past? Would it be possible that the electrical power is output from the IP Phone to the LAN Switch via the LAN cord, so that the LAN Switch is damaged?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...