I have about 10 7970?s that have applied a custom background image to. The custom background is white with colored text. Most of the phones display this correctly with the line appearance or assigned speed dial buttons readable with a solid gray bar and the button assignment in a white font. On three or four of the 7970?s you can not read the button assignment, the solid gray bar is missing and the white display text blends in with the logo. Where is the setting to change this? Why is it working on some but not all?
There are a couple of things you have to think about here. If you use the "idle" field the background is only going to show when the phone goes "idle". When the phone does go idle and the "default" background is being displayed, when a user receives a call they wont be able to see the caller id until they bring the phone out of "idle" status.
I would suggest that you follow the link in the previous post and just add your background to the list of available backgrounds, set it to the one that you want. One extra step though; after you follow the instructions you will need to stop and restart the "TFTP" service on the CCM before the phones will reflect the changes.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...