7970 Time and Date

[cnbalva]

I just put in a new 7970 phone and the time and date are incorrect. Does anyone know where to change this? All other phones, 7940 and 7960 are correct.

[BrianChernish]

The newest load from Cisco (TERM70.5-0-3-0s) should correct this. I have also heard that you cannot use CMloacal as the default time zone for 7970's

[Tom Dillon]

I loaded TERM70.5-0-3-0s and it did not correct the problem. There was an earlier post about using explicit time zone. I created a new Date/Time Group that used the explicit time zone and not the local CM server time and then create a device pool that used the new date/time group. After creating the new Date/Time Group my new 7970 phone has the correct date and time.

[IngGerardo013]

Do  you have the documentation of how to create the the New Date/Time group and the Device pool??

[paolo bevilacqua]

7 years old thread, unlikely that you will get an answer here.

[William Bell]

To create a new Date/Time group in CUCM 8.5:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmcfg/b02dtgrp.html

Device pool:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmcfg/b02devpl.html

If you have a different version of CUCM then go to google and type the following into the search box:

"unified communications manager administration" + 7.1 site:cisco.com

The above would pull the admin guide for CUCM version 7.1

HTH.

Regards,

Bill

[IngGerardo013]

Hello guys, is this solution applicable to a CME (uc-520)?

[William Bell]

No, the information I provided was for Communications Manager. Take a look at this link to see if it helps you.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/troubleshooting/guide/ts_time.html

Regards,

Bill