I have an office with a 2600 router connected via Frame relay to our Head Office.
I require 4 analogue ports to be able to connect via VOIP to the HO and onto a 5300.
Is it possible to use 1 of the 827-4V ADSL routers to interface to the PABX using the POTS port and then VOIP these conectionsusing G729 via the 827's ethernet port to the 2600 and then to the HO.ie the VOIP peer would not point over the ADSL connection which will remain unused?
This would be a simple and cheap solution as the slots on the 2600 are all used so there is no room for FXS ports .This will also allow us to UDP header compression on the 2600 across the FR link..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...