I have a 911 monitor program that polls our CM v4 and we are moving to CM v5 my problem is that the database is fairly inaccessible in v5.
I read Developing Cisco IP Phone Services in the hope that I could configure a service to listen for the number sequence "start" 9 1 1 "connect" and hit a webserver to handle the alerting.
I could not find how to do this anywhere in my book. Is it not possible to make the phone listen for a key combination and trigger a service or is it just not covered in the book. The book was very good about explaining menus and softkeys but I need the key combo 911 to be my trigger.
Using CallManager's JTAPI API, you can start monitoring for 911 calls, and you can find out who has made a call and when. You can also push out a text and/or audio message to a group of phones with the phone display indicating who has called 911. This will be a small custom app that would work on CCM 4/5/6. If I have some free time, may be I should write and post it.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...