Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AA IVR on ITS using a 1760

Hi all.

My ITS AA IVR is not working. When I call the aa-pilot number I get a fast busy tone. I've follow the instructions per the ITS v2.01 manual. Any help is appreciated. Below is the IVR related configuration. I've setup the IVR files in a different flash partition.

Thanks

Gabriel

call application voice auto_att flash:2://its_Cisco.2.0.0.0.tcl

call application voice auto_att aa-pilot 1000

call application voice auto_att operator 1005

call application voice auto_att language 1 en

call application voice auto_att set-location en 0 flash:2://

ephone-dn 1

number 1000

application auto_att

1 REPLY
New Member

Re: AA IVR on ITS using a 1760

Thought this Products configuration guide chat might help you verify your config

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800ca6a5.html#37171

99
Views
0
Helpful
1
Replies