I have two sites A and B setup with AAR. If A calls B and there is no bandwidth AAR works fine. However if user B setup call forward or busy to another phone AAR does not work at all. All I get is a quick beep on B and A get disconnected. Is this a bug or limitation of AAR?
I will test this in lab here soon. The version I will test this on is 3.3.3. Are you CForwarding from B to A via the 4 digit extension ? Have you set AAR prefixes or external phone number masks on the phones properly ?
Yes I call from A to B, but on B phone I set the call forward and busy to reception. Phone B is onhook. I have set all the parameters correctly because phone B will work if I take out CFD and Call Busy.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.