About analog phone connect to Cisco7960 IP phone through FXS port
I want to connect analog phone to Cisco7960 IP phone through FXS port.
I setup dial-peer pots and voip in router near analog phone and dial-peer voip in ITS router,I can dial the dn of 7960 phone from analog phone,but only hear noise.I can't dial analog phone number from 7960 IP phone,it's busy.
Re: About analog phone connect to Cisco7960 IP phone through FXS
if your 7960 is running Skinny (not SIP) then it is connected to Call Manager and you need to define the gateway to the fxs port. You do that in Call Manager. Next, you point your VoIP dial peer to the Call Manager. Then you should be good.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...