Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

About Blind Addressing?

Hello,

I'm try to send messages from a unity server to another unity server on another domain, e-mail messages (SMTP messages) are working very well but when I try to use blind addressing the messages are not delivery... So when I run the Extension Address Utility, then I look at the E-mail address on a user on Active Directory the blind address (location_extension@domain) are not created, the I create it manually, but the messages yet not delivery... I'm using Unity 3.1(5) and Exchange 2000. The IVC is installed and apparently is running without problems....

Can you help me?

4 REPLIES
Community Member

Re: About Blind Addressing?

Hi,

You'll want to use the voice connector released to CCO as v10.0(1), and the accompanying release notes dated 10-FEB-03. The additional proxy addresses on Unity subscribers are no longer required. The 10.0(1) voice connector is supported with Cisco Unity 3.1(5) and it will work much better for you. Both the voice connector and release notes can be obtained at http://www.cisco.com/cgi-bin/tablebuild.pl/unity-voice-connector. Hope that helps.

Community Member

Re: About Blind Addressing?

OK,

I will try.. but this new connector will work with blind_addressing?

Community Member

Re: About Blind Addressing?

Yes it will. Take a look at the release notes that come with the 10.0(1) voice connector download. And also be sure to read the latest Networking in Cisco Unity Guide at http://www.cisco.com/univercd/cc/td/doc/product/voice/c_unity/net/net401/ex/index.htm. That should answer this question and more. Thanks.

Community Member

Re: About Blind Addressing?

OK, Thanks...

92
Views
0
Helpful
4
Replies
CreatePlease to create content