it's normal that a x-lite softphone (mac os x version) registered on CME 4.x system:
- calls correctly all internal numbers (ip phones Cisco)
- the client supports only g711a/u, GSM, iLBC and SPX ... then it uses g711a/u ... but all dial-peer voip use g729, then when I try to call a voip number, cme try to connect that with dial-peer pots, and it doesn't work ... no way to do that? I could only:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...