Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

about cucm6 be

I have an Cisco Call manager 5.1 @ site A and one CUCM 6 BE in other site B.

Can I integrate both sites?. I read something about the BE is not appropriate for branch offices...

There is a WAN Link between A and B.

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: about cucm6 be

Yes, you could.

BE will support up to 20 remote branches, and also support SRST.

With BE, you would only have one server, so you would lose server and voicemail redundancy. Because it targets the commercial mid-market, you would also be limited to 500 users.

You could otherwise configure an intercluster trunk to link the two and maintain the CUCM 5.1 and CUCMBE on the other.

Hope this helps,

Regards,

Michael.

1 REPLY
Cisco Employee

Re: about cucm6 be

Yes, you could.

BE will support up to 20 remote branches, and also support SRST.

With BE, you would only have one server, so you would lose server and voicemail redundancy. Because it targets the commercial mid-market, you would also be limited to 500 users.

You could otherwise configure an intercluster trunk to link the two and maintain the CUCM 5.1 and CUCMBE on the other.

Hope this helps,

Regards,

Michael.

96
Views
0
Helpful
1
Replies