Is there a way to configure the 7940 and 7960 IP phones to allow for a 12 digit acct or authorization code after the long distance number is dialed? Right now, after you call the number there is nothing to activate or to prompt you to be able to enter anything, let alone a code. Appreciate some help with this, thank you in advance.
This question has been asked many many times by lots of people. As of right now there is no easy way to do it. I hope that cisco has it on there road map but another call from some one else to them may push the priority up.
You can use a "route-pattern" in CCM admin that could force users to enter a long cryptic sequence of numbers before their LD number, however, this solution stinks. I have installed IPT systems in a number of environments that require an access code for billing and accounting purposes. In these cases, the phone company is the one who provides the access code funtionality, e.g. AT&T and Qwest have done this for me on dedicated long distance T1's or PRIs. It works great.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.